Appliance Repair in Rancho Cordova, Gold River Included

Give us the ZIP and the appliance's age. A tech diagnoses the washer, fridge or dryer where it stands and puts the repair price in writing.

Sacramento Appliance Care lines up appliance repair in Rancho Cordova and Gold River for washers, dryers, refrigerators, dishwashers, ovens and ice makers. Say what broke and how it's acting up, and we'll get an appliance tech out to find the fault.

The city has two different housing stocks: older neighborhoods in 95670 and much newer tracts in 95742. A washer that quits in a 1970s ranch house and one that quits in a 2010 tract home tend to fail for different reasons, and the repair-or-replace call lands differently too.

Tap water runs from soft to hard depending on the street, and hard water is rough on dishwashers and front-load washers.

Housing and appliance age

Older Homes in 95670, Newer Builds in 95742

In 95742, a fridge, dishwasher or washer that came with the house is usually past the lifespan Consumer Reports says most makers expect. When a builder-grade fridge stops cooling, the tech's first job is to tell you whether it's a fan, a relay or a defrost part, or the sealed system. The first group is usually worth fixing on a fridge that age. The second usually isn't.

In 95670, the machines have mostly been replaced at least once, so the washer may be newer than the house. The hookups often aren't. When a washer leaks in an older house, the tech looks at the supply hoses and the shutoff valves behind it as well as the machine. On a gas dryer or range, say so when you call.

Older kitchen with original wood cabinets, a vintage green range and a newer stainless refrigerator

Washers

Diagnosing a Washer That Won't Drain, Spin or Fill

Washer faults by what you see, with the part the tech usually ends up replacing
What the washer doesWhere the tech looksCommon repair
Ends the cycle with water in the drum The drain pump and its filter, then the hose to the standpipe. Coins and socks end up in the pump. Clearing the pump or fitting a new one.
Drains but never spins The lid switch or door lock, the drive belt or motor coupler, and the motor control. A new lock, switch, belt or coupler.
Roars or grinds louder as the spin speeds up The tub bearings and the seal in front of them. A bearing and seal job. On an older front loader, compare the price with a new washer.
Puddle under the front of a front loader The rubber door boot, the pump housing and the hoses inside the cabinet. A new door boot, hose or pump seal.
Hums but won't fill, or fills slowly The water inlet valve and its screens, plus the supply hoses behind the machine. A new inlet valve, or new hoses on an older hookup.
Door stays locked after the cycle Water still in the drum, the door lock assembly and the control. A drain repair or a new door lock.

Water and dishwashers

Is Hard Water Behind the Dishwasher Trouble?

More than one water supplier serves Rancho Cordova, and the difference matters. Golden State Water's Cordova system blends its own wells with treated surface water, and its latest report shows hardness from about 1.5 to 16 grains per gallon, with an average around 4.4. The county water agency's north system delivered almost all surface water in its latest report and stayed near 3 grains.

At the hard end, minerals coat a dishwasher's heater, clog the spray arms and stick the inlet valve. These are the signs the tech will ask about:

  • A white film on glasses and on the tub walls that keeps coming back
  • Dishes that come out wet, with a cycle that runs longer than it used to
  • Weak spray and grit left on the top rack
  • White crust around the washer's detergent drawer or door boot

A scaled heater, a clogged wash pump or a sticking inlet valve is a repair. The dishwasher repair page covers the other common faults.

The 15-grain line

Whirlpool says water at 15 grains per gallon or more can damage a dishwasher, and the hardest Cordova samples went past that line. If your dishwasher keeps scaling up, tell us when you call so the tech checks the heater and valve first.

Front-load washer with the lower access panel off and the drain pump filter removed, a small sock and a coin on a red towel

Cost

Pricing a Washer or Fridge Repair

Consumer Reports members paid a median of $158 to $214 to fix a front-load washer and $142 to $213 for a high-efficiency top loader. Fridge repairs for common faults like a dead ice maker or a warm fresh-food section mostly ran $150 to $240. A failed compressor is the outlier at a median of about $562.

Consumer Reports says a refrigerator under 10 years old is usually cheaper to fix than replace, and it warns against sinking over 50% of a new appliance's price into an old one. For a 95742 fridge from the build years, that means a fan or relay is worth fixing, and a compressor usually means a new fridge.

You'll have a written price from the tech either way, and the repair only goes ahead on your say-so. If the answer is replace, a dead washer or fridge can go out on one of the city's bulky item pickups.

ZIPs and brands

ZIP Codes, Model Numbers and Brands

We cover 95670, 95741 and 95742, Gold River addresses included. Don't see your ZIP? Call anyway and we'll check your address.

Have the brand and the model number from the rating plate ready. On a washer it sits under the lid or near the door opening, and on a fridge along an inside wall. Each of these brands has a page here:

Service Calls, Warm Fridges and Squealing Dryers

Is there a charge for the tech to come out?

Usually there's a service call charge, and you hear the amount before the visit. Once the tech finds the fault, you get a written price for the repair. California sets rules for both, and the cost guide explains them.

My fridge is warm but the freezer is fine. What's wrong?

Often the evaporator fan or the defrost system. When frost chokes the coil or the fan quits, cold air stops reaching the fresh-food side. The tech checks the fan, the defrost heater and sensor, and the air damper. Move the food to a cooler and call us.

My dryer squeals when it starts. Is that a big job?

Usually not. A squeal at startup tends to come from worn drum rollers, an idler pulley or the drum glides. Those are modest parts next to a new dryer, and the tech confirms which one before pricing it.

Price the washer repair first

Tell us your ZIP (95670, 95741 or 95742), the brand, and what the machine does when it fails. If it's still under warranty, say so.

Call (916) 618-0484
Call (916) 618-0484